Exerpeutic Inversion Table Manual do Utilizador

Inversion TableAssembly InstructionsEP-550TM

9ASSEMBLYStep SixInstall the Front Foam Rollers (F5-1051)• Slide the Foam rollers over each side of the Front Ankle Bar (Figure 12).• Insert the bla

10ASSEMBLYCHANGING THE ROLLER HINGE SETTING• Stand with your legs on either side of the Main Shaft.• Reach under each Roller Hinge with your index fi

If you have any problems assembling the equipment, or questions about its use, please contact customer service at: USA:Teeter 9902 162nd St. Ct. E., P

1. It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent risks of inversion, such as falling on you

ITEMS FOR ASSEMBLYCarefully remove the individual parts from the carton. You should have all of the items listed below. If any items are missing or da

Before BeginningBefore reading further, study the drawing below to familiarize yourself with the important components of your new Teeter Hang Ups inve

4ASSEMBLYStep OneAssemble the A-frame Base (EP-1100) and Install the Handles (F5-1069)• Open the A-frame and make sure the spreader arms are locked,

Step TwoAttach the Upper Support Arms to the Table Bed (EP-1140) • Before following this step, make sure you have read the orange insert that came at

6ASSEMBLYStep ThreeInstall the Roller Hinges (F5-1064) onto the Table Bed (EP-1140)• For ease-of-assembly, rest the Table Bed against the side of the

7ASSEMBLYStep FourAttach the Table Bed(EP-1140) to the A-frame (EP-1100)• Holding each side near the Roller Hinges, pick up the Table Bed and stand a

8ASSEMBLYStep FiveInsert the Main Shaft (EP-1120) into the Table Bed (EP-1140)• Loosen the De-rattler knob on the Main Shaft Housing.• With the heig